CNC cutting machine manufacturers analyze panel furniture cutting machines - operating specifications for electronic cutting saws

When using and operating these cutting equipment, you must follow the specifications, otherwise it will affect normal production.

1. Safety protection requirements

(1) Dust masks must be worn.

(2) No loose clothes, uniform work clothes, and bracelets are strictly prohibited.

(3) The saw blade must be equipped with protective devices.

2. Key points of safe operation

(1) Before operation, check whether the control switch of the panel furniture cutting machine is sensitive, and whether the safety grating and emergency stop switch are in normal state.

(2) Before starting the machine, check that the saw blade of the machine is clean, sharp and free of defects, whether it is locked, and whether the direction is correct.

(3) When the machine is sawing, it is forbidden to open the safety protection curtain, observe or touch.

(4) Non-professionals or professional maintenance personnel of the machine are strictly prohibited to operate the operating system, modify or add any programs without permission, so as to avoid malfunction of the equipment and cause injury.

(5) During the operation of the panel furniture cutting machine, it is strictly forbidden for any part of the body of the operator or bystander to extend into the working range of the machine to watch the operation of the machine.

3. Process parts processing process

(1) Receive planning sheet, material feeding sheet-receiving sheet, and drawing review.

(2) Processing line of panel, side panel and extraction panel: commissioning machine-remaining material test machine-forklift upper plate-manual lower plate-plate stacking-plate conveying-horizontal sawing-vertical sawing-lower workpiece-bracket swing Put-in-process inspection (first inspection).

(3) Processing line of back plate and drawer bottom plate: debugging machine - manual upper plate - longitudinal sawing - transverse sawing - lower workpiece - bracket placement - processing process inspection.

(4) The processing line of the bottom plate, side plate, tail plate, and universal wheel strip: use machine - plate sawing - bracket placement - processing process (inspection).

4. Operation and maintenance procedures for electronic cutting saws

Ready to start

(1) Check whether the air pressure reaches 6-8Bar

(2) Turn on the central dust removal system

(3) Check whether there is looseness between the equipment switch connectors and fasteners, and whether they can be opened normally.

(4) Check whether there is any abnormality in the feeding device of the panel furniture cutting machine, the clamping clip and the automatic molding beam, and whether there are foreign objects nearby.

The above conditions are normal to start the operation.